Posted 14 March 2010 - 11:50 AM
This procedure will vary depending on the custom and parts chosen. Always be certain the parts chosen have enough depth, width, and overall "meat" to support this technique.
1. After choosing the paarts you want to use, carefully cut the hands off at teh wrist or forearm if doing forearm articulation.
2. Chose the right dremel bit. It will vary depending on the size of the available wrist and forearm as well as the size of the peg you use. Here is an image of the bit I use.
3. Now for the tricky part. Drill holes in both the wrist and forearm section. Be certain the holes line up as straight as possible. You don't want a lopsided hand. Also, try not to waddle the hole out too much. You want the fit to be as tight and snug as possible.
4. Now insert your peg in the hand or forearm, which ever you choose. You may have to heat the parts to make the fitting easier, either with a blow dryer or hot water. Use your teeth (my choice) or needle nose pliers to shove the peg in as far as you can. For mine I used the peg from XMO Sabretooth's knees.
5. Now do the same for whichever part is left and put the two parts together. Remember to shove it in as far as you can and heat helps. There ya go!
Posted 15 March 2010 - 09:16 AM
You keep growing in leaps and bounds.
Posted 19 March 2010 - 10:34 PM
i would also like to convert their hip joints to t-bars.
i cant even fathom a way to give iceman t-bar hips....
Posted 19 March 2010 - 11:30 PM
Posted 19 March 2010 - 11:56 PM
Posted 20 March 2010 - 12:03 AM
...now...i should buy a third figure...in case i completely wreck the first 2
Posted 20 March 2010 - 04:08 AM
Posted 22 March 2010 - 09:42 PM
Posted 13 April 2010 - 07:49 PM
Posted 14 May 2010 - 06:36 AM
Posted 27 October 2011 - 12:53 PM
The easiest way is to cast the head then sand the hair off. However, not everyone can cast so I suggest starting with a razor knife then sanding.
Posted 27 October 2011 - 12:54 PM
The only thing I can suggest is try to find a G.I.Joe hand or Star Wars that will fit correctly.
0 user(s) are reading this topic
0 members, 0 guests, 0 anonymous users